I Beam Variable Skew Angle

Right angle support

Butt members together and attach I Beam Variable Skew Angle with 6/No.12 Type 17 Hex Head Screw in each member. Ensure adequate end distance is achieved by having long edge fixed to butt end.

Minimum timber edge distance for screws = 30mm

Minimum timber end distance for screws = 60mm

Supporting at angle

Attach I Beam Variable Skew Angle to beam or girder truss with 6/No.12 Type 17 Hex Head Screw. Supporting member to be minimum 35mm deep. Notch out bottom of carried member 5 mm if required, and fit to I Beam Variable Skew Angle with 1/ Number 12 counter-sunk screw from underneath minimum 35mm long.

NOTES:

Do not over tighten screws

Pre-drill holes for hardwood

Capacities can be doubled for 2 angles if supported member is greater than 70mm thick

Right angle support

Supporting at angles

Supporting at angles

45° support angle